ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · [email protected] · www.ek.plus
CM 8SH CI-TC
USER MANUAL
For the LAN, select the equipment and for connection press:
•
ID.: enter the MAC of the corresponding power supply.
•
KEY: enter the CM Key, if any. If not
“
0
”
.
•
LOCAL IP: the local IP will be entered if connected via LAN from the same network.
•
DESCRIPTION: description.
Using the
“
CM Management
”
software, all modules connected to the power supply can be controlled
and programmed. The function of each of the main side options is explained below:
Connect to the modules via the power supply using the USB connector.
Connect to the modules via the power supply using the LAN interface.
Firmware update button for any of the cards. If any SW is available, the corresponding
card will be displayed with a white triangle in the inner left corner. By double-clicking
the button will change the color to orange and the icon will change from gray to blue.
Clicking the icon will update the FW of all selected cards. It is recommended to update
each button one at a time via a RESET of the power supply at the end.
Reset selected card. This function is not available for all cards.
This option enables loading a programming configuration previously saved in the PC to
the head-end. The configuration file will have a *.dtc extension.
This option enables the programming configuration of a head-end to be saved on the
PC, to be subsequently loaded following the steps of the preceding point.
THE DISTRIBUTION OF THE MODULES MUST BE IDENTICAL TO THAT OF THE *.dtc
FILE.
Data-logger. Enables saving the data of the different head-end modules in a single
*.html. file
Enables changing the output of the DVB-T (COFDM) modules to DVB-C (QAM).
