- 11 -
STEP 3
REMOVING THE PRE-INSTALLED I/0 BRACKET
Unscrew three (3) M3 x 5 screws using Phillips head screwdriver and
remove the I/O Bracket (as shown in the picture). Save the screws and
I/O Bracket for later use!
For this step, you will need:
For this step, you will need:
STEP 2
REMOVING THE BACKPLATE
Carefully unscrew four (4) preinstalled backplate screws (M2.5 x 7 AX1)
and remove the backplate, as shown in the picture. Save the screws and
backplate for later use.
STEP 2
STEP 3
M3 x 5 SCREW
I/O BRACKET
Phillips Head Screwdriver
M2.5 x 7 AX1 SCREWS
BACKPLATE
Phillips Head Screwdriver
