30
Chapter 7 Reference
Chapter 7 Reference
7-1. Arm Installation Procedure
An optional arm (or an optional stand) can be attached by removing the stand section. Please refer to our
web site for the supported optional arm (or optional stand).
Attention
•
When attaching an arm or stand, follow the instructions of the respective User’s Manual.
•
When using another manufacturer’s arm or stand, confirm the following in advance and select one conforming to
the VESA standard.
- Clearance between the screw holes: 100 mm × 100 mm
- VESA mount of the arm or stand, external dimensions: 122 mm x 122 mm or less
- Strong enough to support weight of the monitor unit (excluding the stand) and attachments such as cables.
•
When using another manufacturer’s arm or stand, use the following screws to secure it.
- Screws fixing the stand to the monitor
•
When using an arm or stand, attach it to meet the following tilt angles of the monitor.
- Up 45˚, down 45˚ (when the monitor is in portrait orientation, or when it is rotated 90° counterclockwise to a
landscape orientation)
•
Connect the cables after attaching an arm or stand.
•
Do not move the removed stand up and down. Doing so may result in injury or device damage.
•
The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment damage.
•
Periodically check the tightness of the screws. If not sufficiently tight, the monitor may detach from the arm, which
may result in injury or equipment damage.
Attachment procedure
1.
In order to prevent the panel surface from being damaged, lay the monitor on a
soft cloth spread on a stable surface with the panel surface facing down.
2.
Remove the stand.
Prepare a screwdriver. Using a screwdriver, remove the screws (four) securing the unit and the stand.
3.
Attach the arm or stand to the monitor.
Use the screws that you removed in step 2 to attach the arm (or stand) to the monitor.
