English
2. CABLE CONNECTION
17
Selecting the Active Input
The Input Signal Selection Button on the control panel can be used to select either
SIGNAL 1 or SIGNAL 2 as the active input at any time. Every time the button is
pressed, the input changes. When switching the signal, the kind of the input signal
(Signal1 or 2/Analog or Digital) is displayed for a few seconds on the right top corner
of the screen.
The Priority Input Signal
This function is used to select which PC will have priority to control the monitor
when utilizing two PCs. The monitor constantly checks the input signals and switches
automatically in accordance with the “Input Priority” setting (see table below). Once
a priority is set, whenever a change of signal is detected at the selected input, the
monitor will switch the input to that signal.
In the case of only one signal being present at either input, the monitor automatically
detects and displays that signal.
NOTE
z
When the “1” or “2” is selected, the power saving mode of the monitor activates
only if both PCs are in power saving mode.
Priority setting
Performance
1 (SIGNAL 1)
If signals from both inputs are present, the monitor gives preference
to Signal 1 in the following cases.
z
When the power of the monitor is turned ON.
z
When the signal input to Signal 1 is changed even if active input
was Signal 2.
2 (SIGNAL 2)
If signals from both inputs are present, the monitor gives preference
to Signal 2 in the following cases.
z
When the power of the monitor is turned ON.
z
When the signal input to Signal 2 is changed even if active input
was Signal 1.
Manual
The monitor will not detect signals automatically in this mode. Select
the active input by pressing the Input Signal Selection Button on the
monitor's control panel.
Input Signal Selection Button
