17
Chapter 2 Installation / Connection
2-2. Installing the Product
This product should be installed using an arm or stand.
Attention
• When installing, do so by carefully following the information in the User Manual about the arm or stand.
• Ensure the following and select components that comply with the VESA standards.
- Clearance between the screw holes: 400 mm × 200 mm
- Strong enough to support the weight of the monitor unit (excluding the stand) and attachments such as cables.
• Use the supplied screws when installing.
•
Please follow the specifications for the screw tightening torque. If the tightening is not performed correctly, the
attached part may be damaged, which may result in injury or equipment damage.
• When using an arm or stand, attach it to achieve the following tilt angles of the monitor.
-
Up 45˚, down 45˚
• Connect the cables after attaching an arm or stand.
• The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment damage.
•
Periodically check the tightness of the screws. If not sufficiently tight, the monitor may detach from the arm, which
may result in injury or equipment damage.
1.
Attach the arm or stand to the back of the monitor by aligning the four screw
holes and secure the arm or stand using the screws supplied with the monitor.
Screw tightening torque: Max. 8 N·m
Tool required: Allen wrench (No. 2)
Rear
Screw holes
Unit: mm
200
400
Installation fixture
M8 screw
Cabinet
Depth of insertion
8 mm - 15 mm
