12
Chapter 2 Advanced Adjustment / Setting
Function
Setting range
Description
GPI Setup
GPI1
GPI2
GPI3
GPI4
GPI5
GPI6
GPI7
GPI8
Zoom
POP
Display Direction
Display Direction
Input DisplayPort
Input SDI 4K
Input SDI 1
Input SDI 2
Input SDI 3
Input SDI 4
Input DVI-D 1
Input DVI-D 2
Input DisplayPort
Input SDI 1
Input SDI 2
Input SDI 3
Input SDI 4
Input DVI-D 1
Input DVI-D 2
Red Tally
Green Tally
Undef
Sets functions assigned to each terminal of the GPI terminals.
•
“Zoom”
Switch between the set zoom level and actual size.
•
“POP”
Switches between dual screen (P out P) and single
screen.
•
“Display Direction
”
Rotates or flips main screen.
•
“Display Direction
”
Rotates / flips subscreen.
• “
Input DisplayPort”
Switches main screen input signal to DisplayPort.
• “
Input SDI 4K”
Switches main screen input signal to SDI 4K.
• “
Input SDI 1”
Switches main screen input signal to Input SDI 1.
• “
Input SDI 2”
Switches main screen input signal to Input SDI 2.
• “
Input SDI 3”
Switches main screen input signal to Input SDI 3.
• “
Input SDI 4”
Switches main screen input signal to Input SDI 4.
• “
Input DVI-D 1”
Switches main screen input signal to Input DVI-D 1.
• “
Input DVI-D 2”
Switches main screen input signal to Input DVI-D 2.
• “
Input DisplayPort”
Switches subscreen input signal to DisplayPort.
• “
Input SDI 1”
Switches subscreen input signal to Input SDI 1.
• “
Input SDI 2”
Switches subscreen input signal to Input SDI 2.
• “
Input SDI 3”
Switches subscreen input signal to Input SDI 3.
• “
Input SDI 4”
Switches subscreen input signal to Input SDI 4.
• “
Input DVI-D 1”
Switches subscreen input signal to Input DVI-D 1.
• “
Input DVI-D 2”
Switches subscreen input signal to Input DVI-D 2.
•
“Red Tally”
Sets
(red) displayed at screen top center to On or Off.
•
“Green Tally“
Sets
(green) displayed at screen top center to On or
Off.
• “Undef“
Not set.
Attention
•
When the LOCK function is “On”, only “Control” settings can be changed.
Note
•
The GPI is an edge operation without tally. Operations can be received by setting the terminal potential from
open to the same potential as GND. The edge operation requires a period of at least 200 ms of the same
potential as GND. After the operation, the same potential as GND should be canceled.
•
If you hold down
and
for approximately four seconds, buttons are locked, and the “LOCKED” message
is displayed. If you perform the same operation again, buttons are unlocked, and the “UNLOCKED” message
is displayed.
