40
Chapter 5
5-1. To switch among input signals
The input signal switches each time
is pressed.
When the signal is switched, the active input port name appears at the top right corner of the screen.
5-2. To set input signal selection
Settings
Function
Auto
The monitor recognizes the connector through which signals are input.
When an external device enters the power saving mode, the monitor automatically displays
another signal.
Manual
The monitor displays the signal from the selected connector despite the signal input. Select
the input signal for display using the
operation button.
Procedure
1. Choose “Tools” from the Adjustment menu, and press
.
2. Choose “Input Selection” from “Tools”, and press
.
3. Select “Auto” or “Manual” with
or
.
4.
Press
to exit.
Note
•
When “Auto” is selected for “Input Selection”, the monitor’s power saving function works only when all external
devices are in the power saving mode.
5-3. Skipping Unused Input Signals
This function allows skipping of the set input signals when the input signals are switched.
Procedure
1. Choose “Tools” from the Adjustment menu, and press
.
2. Choose “Mode Skip” from “Tools”, and press
.
3. Use
or
to select the mode to change, and press
.
4. Select “-” or “Skip” with
or
.
5.
Press
to exit.
Attention
•
You cannot set all the modes “Skip”. Set at least one mode to “-”.
