10
Appendix B
Specifications
(Specifications subject to change without notice)
Display
Easy to Read, Yellow Text on Black Background
Dynamic Range
400mW/cm
2
- 40 Watt/cm
2
Accuracy
±
10% of reading,
±
2% of full scale,
±
5% typical
Repeatability
±
1-3% typical, dependent on source, and equipment stability, unit alone better than
±
1%
Spectral Response
Approximately cosine
Spectral Ranges
1-channel continuous monitoring. L395 model: 370-420nm
Spatial Response
Approximately cosine
Smooth Modes
ON: 25 samples/sec; OFF: 2048 samples/sec; Profile: 128 samples/sec
Operating Temperature
0-75°C Internal temperature; tolerates high external temperatures for short periods (audible alarm indicates overheat)
Time-Out Period
2 minutes DISPLAY mode (no key activity). A no time-out mode can be activated by EIT-IM.
Profiling Memory Capacity
Sufficient for >100 minutes
Battery / Battery Life
Two user-replaceable AAA Alkaline Cells ; Approx. 20 hours with display on
Dimensions
4.60 x 0.50 inches; 117 mm x 12.7 mm (D x H)
Weight
10.1 ounces (289 grams)
Package Material
Aluminum, stainless steel
Carrying Case Material
Cut polyurethane interior, scuff resistant nylon exterior cover
Carrying Case Weight
10.1 ounces (289 grams)
Carrying Case Dimensions
10.75 x 3.5 x 7.75 inches; 274 x 89 x 197 mm (W x H x D).
Regulatory Statements
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
This equipment is a Class A device, suitable for use in all establishments other than domestic and those directly connected to a low voltage power supply network which
supplies buildings used for domestic purposes.
This equipment is in conformity with the following standards and therefore bears CE marking:
•
IEC 61326-1:2005
•
EN55011: 1998
•
EN61000-4-2: 1995, A1: 1998, A2: 2001
•
EN 61000-4-3: 2002, A1: 2002
Following the provisions of the applicable directives:
•
98/34/EEC and amendments
•
89/336/EEC and amendments.
Designed and manufactured in the USA. Patent Pending.
