Fix the meatal cover overturn to the seat
of the oven overturn on the cooktop,which
is packaging as the accessories
Electrical
connection
Caution
!
All electrical work should be carried out by a suitably qualified and authorized electrician.
No alterations or willful changes in the electricity supply should be carried out.
Fitting
guidelines
The cooker is manufactured to work with three-phase alternating current (400V 3N~50Hz).
The voltage rating of the cooker heating elements is 220-240V. Adapting the cooker to operate
with one-phase current is possible by appropriate bridging in the connection box according
to the connection diagram below. The connection diagram is also found on the cover of the
connection box. Remember that the connection wire should match the connection type and
the power rating of the cooker.
CONNECTION DIAGRAM
Caution! Voltage of heating elements 230V
Caution! In the event of any connection the safety
Wire must be connected to the
E terminal.
Recommended
type of
connection
lead
1
For 230V earthed one-phase
connection, bridges connect 1-2-3
terminals and 4-5 terminals, safety
wire to
.
L1
N
E
H05VV-F3G4
2
For 400/230V earthed two-phase
connection, bridges connect 2-3
terminals and 4-5 terminals, the safety
wire to
L1
L1
E
N
N
L2
L2
H05VV-F4G2,5
3
For 400/230V earthed three-phase
connection, bridges connect 4-5
terminals, phases in succession 1,2
and 3, earth to 4-5, the safety wire to
.
N
N
E
L1
L1
L2
L3
H05VV-F5G1,5
L1=R, L2=s, L3=T, N=earth terminal, E=safety wire terminal
1
2
3
4
The connection cable must be secured in a strain-relief clamp.
Caution
!
Remember to connect the safety circuit to the connection box terminal marked with
. The
electricity supply for the cooker must have a safety switch which enables the power to be
cut off in case of emergency. The distance bet
ween the working contacts of the safety
switch must be at least 3 mm.
Before connecting the cooker to the power supply it is important to read the information on
the data plate and the connection diagram.
INSTALLATION
8