C)
Suction
As an accessory, our
PTX-suction cover
(Art.-No. 40005) with a conical connecting piece for industrial
vacuum cleaners is available. It can be quickly fixed to the protective cover by means of 3 knurled-head screws.
D) Grinding belt accessory
1.
By fitting our abrasion-proof
PTX-grinding belt roll
, you can rapidly convert the
PTX 500
into a belt
grinding tool for working round stock, e.g. pipes.
2.
For this the protective cover is swung back and locked by loosening the clamping ring (on the motor
gear), so that the grinding and polishing belts can work completely freely in the forwards direction.
E) Grinding belt use
The grinding or polishing belt is centrally moved over the work piece and grinding belt roll, pulled tight rear-
wards and used with roughly step B-C.
The belt works over the desired points by tensioning and lateral displacement.
F) Maintenance
1. Carbon brushes:
Only wear carbon brushes up to the white mark.
Only use the replacement carbon brushes supplied by
us
. Our
guarantee obligations no longer apply
, if you do not use our carbon brushes.
Pull the plug out of the socket, loosen screws
A
and slide back cover
B
. Disconnect cords, remove carbon
brushes, clean the carbon holder with pressure-air. Insert new carbon brushes (which must not jam in the
carbon holder). Insert contact discs of the cords in the lug adapter plug and slide on to the carbon holder
contact plate and refit the compression springs. Check the correct positioning of the switch and again mount
the cover (do not jam in the cords). Sparking of the brush can be observed through the air inlet slots. Switch
off the machine immediately in the case of strong sparking. To avoid serious damage as a result, it is advis-
able to send the machine to us.
2. Cleaning:
Metal dust deposits in the interior of the machine can be prevented by blowing out with compressed air
through the air inlet slots.
3. Gear:
Do not loosen the screws on the gear head within the guarantee period, because otherwise our guarantee no
longer applies. Replace the gear grease after about 1,500 operating hours. By loosening screws Pos.
210
, the
gear cover Pos.
213
can be removed, the old gear grease removed and replaced by 16 g gear grease.
Technical Data:
1,600 Watt
, 220 – 240 Volt, 50 Hz. (110 Volt only available with 1,300 Watt!). Continuous speed regulation by
fitted tachogenerator (speed-stable). Weight about 3,5 kg.
Noise/vibration information
: The typical weighted acceleration is 7 m/s². Typically the A-weighted noise lev-
els are: Sound pressure level: 87 db (A). Sound power level: 100 db (A). Wear ear protection!
Guarantee:
A 12 month guarantee (as from invoice date) is given for all technical and mechanical parts, except in the case of
outside culpability.
Spares can be supplied according to the list. We will carry out necessary repairs.
POLY-PTX
®
500
