GB
- 22 -
5.3 Fitting the suction hose (Fig. 3, 10, 11)
Connect the suction hose (10) to the correspon-
ding connector on the wet and dry vacuum clea-
ner, depending on the application required.
Vacuuming
Connect the suction hose (10) to the suction hose
connector (8)
Blowing
Connect the suction hose (10) to the blow con-
nector (9)
One or more of the elements which make up the
3-part suction tube (11) can be attached to the
suction hose (10) to extend it. The adapter (17)
must be inserted between the suction tube (10)
and the combination nozzle (12) or crevice nozzle
(16).
5.4 Suction nozzles
Combination nozzle (12)
The combination nozzle (12) with attachments is
for vacuuming solids and liquids over medium to
large areas. The crevice nozzle (16) is specially
designed for cleaning cervices and edges.
6. Operation
Important!
Switch o
ff
the equipment if liquid or foam is
emitted with the exhaust air when wet vacuum
cleaning.
6.1 On/O
ff
switch (Fig. 1)
Switch position 0: O
ff
Switch position I: On
6.2 Dry vacuuming
Use the dirt bag (14) and the additional
fi
lter (18)
for dry vacuuming (see point 5.2).
Always ensure that the
fi
lters are perfectly secure.
6.3 Wet vacuuming
For wet-vacuuming, use the foam
fi
lter (15) (see
point 5.2).
Check that the
fi
lter is securely
fi
tted at all times.
Important.
When wet vacuuming, the
fl
oating safety switch
(5) turns o
ff
the wet and dry vacuum cleaner auto-
matically when the maximum level is reached.
Important!
The wet and dry vacuum cleaner is not suitable
for the vacuuming of combustible liquids.
For wet vacuuming, use only the supplied foam
fi
lter.
6.4 Blowing
Connect the suction hose (10) to the blow con-
nector (9) on the wet and dry vacuum cleaner.
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
authorized after-sales service or similarly trained
personnel to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a quali
fi
ed electrician
and/or an authorized service agent.
Danger!
The carbon brushes should not be rep
laced by anyone but a quali
fi
ed electrician or the
authorized service technician.
Anl_SA_TH_VC_1250_S_SPK8.indb 22
Anl_SA_TH_VC_1250_S_SPK8.indb 22
12.10.2017 09:08:01
12.10.2017 09:08:01
