EINHELL TC-RH 900/1, Оригинальная инструкция по эксплуатации

Страница: 23 / 40

GB
- 23 -
•
Important! Follow all safety regulations in your
country applicable to the installation, use and
maintenance of the machine.
•
Chisel bits and drill bits can be inadvertently
thrown out from the machine and cause seri-
ous injury:
•
Always check that the chisel bit or drill bit is
firmly locked in the chuck before you start
work.
•
Check the chuck for wear or damage at re-
gular intervals.Do not start a hammering tool
until it is pressed against a workpiece (wall,
ceiling, etc.).
•
Always unplug the hammer drill when you
have finished working and remove the chisel
bit or drill bit from the tool.
•
Always unplug the machine before changing
chisel bits or drill bits etc.
•
Protect eyes and assistants from small flying
parts and splinters. Wear a helmet! Erect a
screen wall!
•
Use workgloves to protect fingers from crus-
hing and skin from grazing.
•
Vibrations can be harmful to the hand-arm
system: Keep the impact time of vibrations to
a minimum.
•
Always keep the power cable away from whe-
re you want to drill.
•
Keep the machine out of children’s reach.
•
Always hold the machine with two hands
when it is running and make sure of your
footing.
•
Make sure that the switch on the machine is
set to the correct position for the work you
want to perform before you put the machine
into opera-tion. If the switch is not in the cor-
rect position you risk suffering bodily injury
when the machine starts to run.
This appliance is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Do not lose these safety instructions
2. Layout and items supplied
2.1 Layout (Fig. 1)
1. Dust guard
2. Locking sleeve
3. Rotary switch for rotation stop facility
4. ON/OFF switch
5. Rotary switch for hammer stop facility
6. Additional handle
7. Depth stop
8. Handle
2.2 Items supplied
Please check that the article is complete as
speci fi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or su ff ocating!
•
Hammer drill
•
Additional handle
•
Depth stop
•
Dust collection device
•
Original operating instructions
Anl_TC_RH_900_1_SPK8.indb 23 Anl_TC_RH_900_1_SPK8.indb 23 20.08.15 16:14 20.08.15 16:14