EINHELL RT-AP 1050E, Оригинальная инструкция по эксплуатации, Страница: 3 / 6

GB
7
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values determined in accordance with
EN 60745.
Cutting wooden boards (front handle)
Vibration emission value ah = 17.465 m/s²
K uncertainty = 1.5 m/s
2
Cutting wooden boards (rear handle)
Vibration emission value ah = 19.837 m/s²
K uncertainty = 1.5 m/s 2
Cutting wooden beams (front handle)
Vibration emission value ah = 17.746 m/s²
K uncertainty = 1.5 m/s 2
Cutting wooden beams (rear handle)
Vibration emission value ah = 18.825 m/s²
K uncertainty = 1.5 m/s
2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Changing the saw blade (Fig. 2)
Always switch off and unplug the multi-saw before
working on the machine or changing the saw blade.
Press the lever for changing the saw blade (6) as
shown in Figure 2 until the saw blade (4) lets itself be
slipped into the slot of the blade holder (a). Then
release the lever for changing the saw blade (6). The
lever will return to its starting position and lock the
saw blade in place (4). Pull on the blade (4) to check
whether it sits tightly in the holder (a). To remove the
saw blade (4), proceed in reverse order.
5.2 Adjusting the soleplate (Fig. 3)
Important.
Pull out the power plug.
To adjust the soleplate (5), loosen the locking lever
for the soleplate (8) until the soleplate (5) can be
moved. Set the required distance and refasten the
lever (8).
Check that the soleplate is secure.
Anleitung_RT_AP_1050_E_SPK7:_ 10.02.2011 9:27 Uhr Seite 13