EINHELL RT-AG 115, Оригинальная инструкция по эксплуатации

Страница: 26 / 40

26
GB
other grinding/sanding wheels.
e) Do not used worn grinding/sanding wheels
from larger electric tools. Grinding/sanding
wheels for larger electric tools are not designed
for the higher speeds of smaller electric tools and
may break.
Other special safety information for cutting-off
wheels
a) Avoid blocking the cutting-off wheel or
applying excessive contact pressure. Do not
make any excessively deep cuts.
Overloading
the cutting-off wheel will increase the stress on it
and its susceptibility to jam or block and therefore
the possibility of recoil or of the grinding wheel
breaking.
b) Avoid the area in front of and behind the
rotating cutting-off wheel. If you move the
cutting-off wheel in the workpiece away from
yourself, in the event of recoil the electric tool and
the rotating wheel may be catapulted directly
towards you.
c) If the cutting-off wheel jams or you interrupt
your work, switch off the tool and hold it still
until the wheel has reached a complete
standstill. Never attempt to pull the cutting-
off wheel out of the cut whilst it is still
rotating, otherwise it may suffer recoil.
Find
and rectify the cause of the jam.
d) Do not switch the electric tool on again whilst
it is inside the workpiece. Allow the cutting-
off disk to reach its full speed before you
continue the cut with care.
Otherwise the
wheel may catch, jump out of the workpiece or
cause recoil.
e) Support panels or large workpieces to
reduce the risk of recoil by a jammed cutting-
off wheel.
Large workpieces may sag under their
own weight. The workpiece must be supported on
both sides of the wheel both near the cut and also
at the edge.
f) Be particularly careful with “pocket cuts” in
existing walls or in areas which you cannot
see clearly.
As the cutting-off disk enters the cut
it may suffer recoil if it cuts into gas or water
pipes, electric cables or other objects.
Do not lose these safety instructions
2. Layout and items supplied (Figure 1)
2.1 Layout
1. Spindle lock
2. ON/OFF switch
3. Additional handle
4. Guard
5. Flange nut wrench
2.2 Items supplied
n
Open the packaging and take out the equipment
with care.
n
Remove the packaging material and any
packaging and/or transportation braces (if
available).
n
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
transport damage.
n
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
n
Additional handle
n
Guard
n
Flange nut wrench
n
Original operating instructions
3. Proper use
The angle grinder is designed for grinding metal and
stone when using the appropriate grinding wheel and
guard.
Caution! To cut metal and stone the grinder/sander
may only be used when the guard (available as an
accessory) is mounted.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Anleitung_RT_AG_115_SPK8a__ 24.01.13 10:13 Seite 26