EINHELL HKLO 2000, Оригинальная инструкция по эксплуатации

Страница: 10 / 36

7.3 Thermostat control (Fig. 1 / Item 2):
Switch on the required heating output. Turn the
control to “MAX” until the required room temperature
has been reached. Then turn down the control until
you hear a clear click. The thermostat control will
switch the radiator on and off automatically to
maintain the room temperature at an almost constant
level. However, this presupposes that the radiator has
sufficient output to cover the heating requirements for
the room.
7.4 Overheating guard
In case of excessive heating, the heating function
shuts down automatically. The fan and the indicator
light (Fig. 1/Item 3) remain on.
If this occurs, turn off the equipment, disconnect the
mains plug and wait a few minutes for the equipment
to cool. After eliminating the cause (e.g. a covered air
grille), the equipment can be switched on again. If the
overheating guard triggers repeatedly, please contact
your customer service center (in Germany
ISC GmbH).
7.5 Oscillation function (Fig. 1 / Item 5)
Set the fan mode or heat mode as describe above,
turn the switch (Fig. 1 / Item 5) to “I”. The device
swivels 45° to the left and 45° to the right (oscillation).
To switch off the oscillation function and have the
device blow in one specific direction set the switch to
“0”.
8. Cleaning, maintenance and ordering
of spare parts
8.1 Cleaning
Before carrying out any cleaning and
maintenance work the equipment must be turned
off, disconnected from the power supply and
cooled down.
Use a damp cloth to clean the casing.
Remove dust pollution with a vacuum cleaner.
8.2 Servicing
Maintenance and repair work may only be carried
out by an electrical servicing contractor or ISC
GmbH.
Check the mains lead at regular intervals for
signs of defects or damage. A damaged mains
lead may only be replaced by an electrician or
ISC GmbH in compliance with the relevant
regulations.
There are no parts inside the equipment which
require additional maintenance.
8.3. Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
9. Storage
Store the equipment and accessories out of children’s
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
10. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
10
GB
Anleitung_HKLO_2000_SPK7_2:_ 28.02.2012 9:20 Uhr Seite 10