EINHELL GH-PM 51 S HW-E, Руководство по эксплуатации

Страница: 34 / 48

GB
- 34 -
The red lamp on the charger will indicate that the
battery pack is being charged. After 8-9 hours the
battery will be fully charged. This will be indicated
by the green lamp on the charger. Please do not
charge the battery for longer than 12 hours as this
may destroy the battery.
When charging is completed (the green lamp shi-
nes), disconnect the charger from the mains pow-
er supply. Connect the battery plug to the mower’s
electrical system plug and fi t the battery cover.
Important. Charging may create dangerous ex-
plosive gas and therefore you should avoid spark
formation and naked fl ames whilst the battery is
charging.
Calculating the charging time:
The charging time depends on the charge status
of the battery. If the battery is fully discharged,
the approximate charging time can be calculated
using the following formula:
Charging time/h =
Battery capacity in Ah/Amp. (arithmetic charging
current)
Example = 4 Ah/0.4 A = 10 h max.
A high initial current, approximately equal to the
rated current will fl ow in a normally discharged
battery. As the charging time increases, the char-
ging current will fall.
5.6 Setting the cutting height
Important. Adjust the cutting height only
when the engine is switched o ff and the plug
boot has been pulled.
•
Before you begin to mow, check to ensure
that the blade is not blunt and that none of the
fasteners are damaged. To prevent any imba-
lance, replace blunt and/or damaged blades
as a set only (if applicable). To carry out this
check, first switch off the engine and pull the
spark plug boot.
•
The cutting height is centrally adjusted with
the cutting height adjustor lever (Fig. 7/Item
8). Different cutting heights can be selected.
•
Actuate the cutting height adjustor lever and
pull it to the required position. Let the cutting
height adjustor lever click into position.
6. Operation
Important.
The engine is supplied without oil and petrol.
Therefore, be sure to add oil and petrol befo-
re starting the engine.
The battery is not connected when you take deli-
very of the machine. Please connect the battery
as described in section 5.2 before you use the
machine for the fi rst time.
If the machine has not been used for some time,
charge the battery fully (section 5.5) before using
it again.
In order to avoid any unintentional start-ups of the
lawn mower, it comes equipped with an engine
brake (Fig. 5a/Item 1a) which must be pulled back
before the engine can be started. When the engi-
ne start/stop lever is released, it must return to its
initial position, at which point the engine automati-
cally switches o ff .
Starting up with the electric starter
Ensure that the ignition cable is connected to the
spark plug. Activate the fuel pump (primer) three
times (Fig.6/Item 2).
Stand behind the mower. Use one hand to pull
back and hold the engine start/stop lever (Fig.
5b). Start the engine by turning the ignition key in
the ignition lock (Fig. 1/Item 22). Once the engine
has started, turn the ignition key immediately
back to its initial position. If you actuate the igniti-
on key again while the engine is running, you will
damage the starting system.
Starting up with the reversing starter
Ensure that the ignition cable is connected to the
spark plug. Activate the fuel pump (primer) three
times (Fig. 6/Item 2).
Stand behind the mower. Use one hand to pull
back and hold the engine start/stop lever (Fig.
5b). Start up the engine with the reversing starter
(Fig. 1/Item 9). To do this, pull the handle out
approx. 10 – 15 cm (until you feel resistance) and
then start the engine with a sharp pull. If the engi-
ne does not start, pull the handle again.
Anl_GH_PM_51_S_HW_E_D_GB.indb 34 Anl_GH_PM_51_S_HW_E_D_GB.indb 34 02.02.15 08:30 02.02.15 08:30