4. SETUP
5. OPERATE
MAX.
HEAD 8.5M
MAX.
IMMERSION
DEPTH 7M
DISCHARGE POINT
POWE
R
CAB
LE:
10M
WATER LEVEL
FLOAT SWITCH
WATER CONTAINER
OUT
LET
HO
SE
WARNING:
ThE POWER SUPPLY FOR ThIS PRODUCT MUST
BE PROTECTED BY A RESIDUAL CURRENT DEvICE (RATED AT
30MA OR LESS). A RESIDUAL CURRENT DEvICE REDUCES ThE
RISk OF ELECTRIC ShOCk.
IMPORTANT:
BEFORE SUBMERGING ThE PUMP IN WATER,
UNWRAP ThE POWER CABLE AND ENSURE ThE PLUG IS CLEAR
OF ANY DAMP LOCATIONS.
CAUTION:
YOUR PUMP hAS ThE CAPACITY TO PUMP WATER
WITh A NON SOLID PARTICLE SIzE OF UP TO 30MM IN
DIAMETER.
1. Immerse the pump in the
water. For deep water, use a
rope (not included) and secure
it to the suspension eyelet.
Set the pump in the desired
position within the work area
or tank.
2. Insert the plug into the mains
power socket. Where possible
avoid using extension cords as
this can lead to a voltage drop
which may cause power loss
and overheating. Switch on the
mains power to operate pump.
3. To stop operation, turn off the mains power. The pump will also stop
operation automatically once the float switch reaches the minimum
water depth (10mm).
1. Ensure the outlet hose is connected correctly.
3. Adjust the float switch adjustor to allow the pump to switch on and off at
the desired water height.
CAUTION:
NEvER CARRY, LIFT OR PULL UP ThE PUMP BY ThE
POWER CORD. ThIS WILL DAMAGE ThE UNIT.
CAUTION:
ThIS PRODUCT IS INTENDED FOR PUMPING WATER
IN A hOME DOMESTIC APPLICATION. DO NOT USE IT FOR
CORROSIvE, ABRASIvE, ExPLOSIvE OR DANGEROUS LIqUIDS.
2. Ensure the distance from the surface of the water to the highest point
that you wish to deliver the water does not exceed 8.5 metres.
4. Ensure that the container is large enough to allow the float
switch to move freely and function effectively, a minimum area of
50x50x50cm is required.
5. Ensure the pump is placed on a flat and level surface, there are no
obstructions to the suction base and it is clear of mud or sediment.
Before starting, perform a few simple checks:
Suction Level Control
The pump suction level control can be set by rotation of the Pump Housing.
Securely hold the Intake Cage between your feet and rotate the Pump
Housing for either clean or dirty water operation.
•
Lift
UP
and rotate the pump
housing counter-clockwise as
far as possible for
DIRTY
water.
•
Rotate the pump housing
clockwise
DOWN
as far as
possible for
CLEAN
water.
•
In manual mode for clean water use, water can be sucked down to a level
of 1mm
NOTE:
For the pump to operate for clean water use in manual mode there
must be a minimum depth of 10mm of water.
OPERATION
Clean Water Use
Dirty Water Use
Eyelet
