EINHELL GC-PM 46/2 S HW-E, Оригинальная инструкция по эксплуатации

Страница: 38 / 192

GB
- 38 -
and is sharp. If the contrary is the case, sharpen
the blade or replace it. In the event that the blade
strikes an object, immediately switch o ff the lawn
mower and wait for the blade to come to a com-
plete stop. Then inspect the condition of the blade
and the blade mount. Replace any parts that are
damaged.
Tips for proper mowing:
1. Pay attention to ensure that you do not run
into or over anything that could damage the
mower. The lawn mower could be damaged
and/or the machine could in fl ict bodily injury.
2. A hot engine, exhaust or drive unit can burn
the skin if touched. Do not touch these parts.
3. Use extra caution when mowing on inclines
and steep grades.
4. Insu ffi cient daylight or an insu ffi cient level of
arti fi cial light is one reason not to mow.
5. Check the mower, the blade and other parts
if they have struck a foreign object or if the
equipment vibrates more than usual.
6. Do not make any adjustments or repairs until
the engine has been switched o ff . Pull the
plug boot.
7. Pay special attention if you are mowing direct-
ly next to a street or are close by one (tra ffi c).
Always keep the grass chute pointed away
from the street.
8. Avoid mowing in places where the wheels
have trouble gripping or mowing is unsafe in
any other way. Before you back up, ensure
that nobody is standing behind you (espe-
cially little children, who are more di ffi cult to
see).
9. When mowing over thick, high grass, select
the highest cutting level and mow at a slower
speed. Before you remove any grass or blo-
ckages of any kind, switch o ff the engine and
pull the plug boot.
10. Never remove any safety-related parts.
11. Never fi ll the engine with petrol when it is hot
or is running.
6.6 Emptying the grass basket
When the debris bag is full, the air throughput will
be low and the level indicator (4b) will be up close
against the debris bag (Fig. 21). Empty the debris
bag and clear out the ejector chute.
Danger! Before taking o ff the debris bag,
switch o ff the engine and wait until the blade
has come to a stop.
To take o ff the grass basket, use one hand to lift
up the chute fl ap and the other to grab onto the
basket carry-handle. Remove the basket (Fig. 4a).
For safety reasons, the chute fl ap automatically
falls down after removing the grass basket and
closes o ff the rear chute opening. If any grass
remains in the opening, it will be easier to restart
the engine if you pull the mower back approxi-
mately 1m.
Do not use your hands or feet to remove clippings
in or on the mower housing, but instead use suita-
ble tools such as a brush or a hand broom.
In order to ensure that the majority of grass clip-
pings are picked up, the inside of both the grass
bag and especially the air grill must be cleaned
after each use.
Reattach the grass bag only when the engine is
switched o ff and the blade is stopped.
Using one hand, lift up the chute fl ap, while grab-
bing onto the basket handle with the other. Hang
in the basket from the top.
6.7 After mowing
1. Allow the engine to cool before you put the
lawn mower in an enclosed area.
2. Remove grass, foliage, grease and oil before
storing the mower. Do not place any objects
on top of the mower.
3. Before using the mower again, retighten all
nuts and screws. Tighten all screws which
were slackened.
4. Also be sure to empty the grass basket.
5. Disconnect the spark plug boot to prevent
unauthorized use.
6. Ensure that you do not park the mower next
to any source of danger. Petrol fumes can
lead to explosions.
7. Only original parts or parts approved by the
manufacturer may be used for repairs (see
address on the warranty certi fi cate).
8. Empty the petrol tank with a petrol extraction
pump if you are not intending to use the mo-
wer for an extended period of time.
9. Tell your children not to use the mower. It is
not a toy.
10. Never place petrol near an ignition source.
Always use a can that is approved to store
petrol. Keep petrol away from children.
11. Oil and maintain the equipment.
12. How to switch o ff the engine:
All you have to do to switch o ff the engi-
Anl_GC_PM_46_2_S_HW_E_SPK1.indb 38 Anl_GC_PM_46_2_S_HW_E_SPK1.indb 38 22.10.2015 16:29:13 22.10.2015 16:29:13