Caution! When using electric tools it is
imperative to take the following basic safety
precautions in order to reduce the risk of electric
shock, injury and fire. Read and take note of
these instructions before you use this tool.
Follow all these safety regulations before and
while working with the belt and disk
sander/grinder.
Do not lose these safety regulations.
When working outdoors, use only extension
cables that are approved for outdoor use and
which are marked accordingly.
Concentrate on what you are doing. Take a
sensible attitude to your work. Never use the tool
when you are tired.
Never use a tool with a switch that cannot be
turned on and off.
Caution! The use of plug-in tools and
accessories other than those intended may put
you at risk of injury.
Always pull the plug out of the power socket
before adjusting or servicing the machine.
Give these safety regulations to all persons who
work on the machine.
Never use tools or attachments with insufficient
power for the job in hand.
Never use tools on jobs for which they were not
intended!
Make sure you stand squarely and keep your
balance at all times.
Check the tool for possible damage!
Each time before re-using the tool, carefully
check that the guards or any slightly damaged
parts are working as intended.
Check that the moving parts are in good working
order, that they do not jam, and that no parts are
damaged. Make sure that all parts are fitted
correctly and that all other operating conditions
are properly fulfilled.
Unless otherwise stated in the operating
instructions, damaged guards and parts have to
be repaired or replaced by an authorized service
center.
Have damaged switches replaced by a customer
service workshop.
This tool complies with the pertinent safety
regulations.
The maximum gap between the sanding/grinding
disk (13) and the sanding/grinding table (14)
must not be allowed to exceed 1.6 mm.
Always use the stop rail (12) or sanding/grinding
table (14) when working.
Please also comply with the general safety
instructions contained in the supplementary
sheet!
5. Technical data
Voltage:
230V ~ 50Hz
Power rating:
375 W S2 30 min
Sanding/grinding disk:
n
0
: 1450
min
-1
Diameter: 150
mm
Swivel range:
0°-45°
Cross stop:
-60° to + 60°
Belt sanding/grinding unit:
v
0
: 4.6
m/s
Size:
915 x 100 mm
Sound pressure level L
pA
: 78,6
dB(A)
Sound pressure level L
WA
:
91,6 dB(A)
Load factor:
A load factor of S2 30 min (intermittent periodic
duty) means that you may operate the motor
continuously at its nominal power level (375 W)
for no longer than the time stipulated on the
specifications label (30 minutes ON period).
If you fail to observe this time limit the motor will
overheat. During the OFF period the motor will
cool again to its starting temperature.
6. Before putting the machine into
operation
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong stand.
All the covers and safety devices have to be
properly fitted before the machine is switched
on.
The sanding/grinding belt and sanding/grinding
disk must be able to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the sanding/grinding paper is correctly fitted
and that the machineʼs moving parts run
smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
12
GB
Anleitung BT-US 400_SPK1:_ 09.01.2008 16:26 Uhr Seite 12
