EINHELL 45 050 04, Руководство по эксплуатации, Страница: 17 / 62

Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1 / 2)
1. Speed controller
2. Direction selector switch
3. ON/OFF/Emergency Stop switch
4. Hand wheel for longitudinal feed
5. Table
slide
6. Compound slide
7. Cross slide
8. Crank with scale for transverse feed (compound
slide)
9. Scale for conical turning
10. Feed locking lever
11. Round scale for feed
12. Crank with scale for hand feed (cross slide)
13. Leadscrew
14. Machine sump
15. Lathe table
16. Crank handle for quill
17. Tailstock
18. Screw for tailstock adjustment
19. Clamp lever for quill
20. Quill with scale
21. Centering pin
22. Safety guard
23. Chuck
24. Clamp lever for tool holder
25. Clamp screws for turning tool
26. Clamp jaw
27. Three-jaw chuck
28. Three-jaw chuck clamp screw
29. Gear wheel box
30. Feed direction lever
31. Power cable
32. High / Low speed selector switch
33. Switch guard
34. Motor cover
35. Rear splash guard
36. Tailstock
37. Three-jaw chuck safety cover
38. Clamp jaws
39. Allen key
40. Open-ended wrench
41. Chuck jaw wrench
42. Oil bottle
43. Gear wheels
3. Intended use
The lathe is designed for the longitudinal and surface
lathing of round or regularly shaped 3, 6 or 12-sided
workpieces made of metal, plastic or similar materials
with a maximum diameter of 70 mm and a length of
approx. 300 mm. The hollow spindle also makes it
possible to clamp longer workpieces with a maximum
diameter of 20 mm.
The leadscrew means that the lathe can also be used
for thread turning.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have to
be acquainted with this manual and must be informed
about the machine’s potential hazards. It is also
imperative to observe the accident prevention
regulations in force in your area. The same applies for
the general rules of health and safety at work.
The manufacturer will not be liable for any changes
made to the machine nor for any damage resulting
from such changes. Even when the equipment is
GB
17
Anleitung_BT_ML_300_SPK 1:_ 23.11.2007 9:32 Uhr Seite 17