EINHELL 4466239, Оригинальная инструкция по эксплуатации

Страница: 15 / 32

GB
- 15 -
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect con-
ditions.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment’s construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Dust extraction
5.1.1 Installing the dust bag
(Figure 3/Item 12)
Slide the dust bag (12) on to the connection for
the dust extractor (6). Follow the instructions abo-
ve in reverse order to remove the dust bag.
The dust is extracted straight from the sanding/
grinding belt into the dust bag.
Important. For health safety reasons it is impera-
tive that you use a dust bag.
5.2 Changing the sanding / grinding belt (Fig.
4-5/Item 11)
•
Pull the clamping lever (10) to the outside to
relieve the tension in the sanding/grinding
belt.
•
Pull the used sanding/grinding belt off the
drive rollers.
•
Slide the new sanding/grinding belt on to the
drive rollers.
•
Ensure that the direction of the sanding/grin-
ding belt (arrows on the inside of the sanding/
grinding belt) is identical to the direction of
the belt sander/grinder (arrow over the rear
drive roller).
•
Press the clamping lever (10) to the rear to
tension the sanding/grinding belt.
5.3 Adjusting the position of the belt
(Fig. 6/Item 2)
•
Hold the belt sander/grinder with the sanding/
grinding plate at the top.
•
Switch on the belt sander/grinder.
•
By turning the setting screw (2) the belt positi-
on should be set so that the sanding/grinding
belt is at the center of the two drive rollers.
6. Operation
6.1 Switching ON/OFF (Fig. 7)
To switch on:
Press the ON/OFF switch (5).
Continuous operation:
Secure the switch (5) with the locking button (4).
To switch o ff :
Press the ON/OFF switch (5) brie fl y.
The machine can be operated on a temporary
or permanent setting.
6.2 Setting the belt speed (Fig. 8/Item 3)
You can select the belt speed by turning the set-
ting knob (3).
PLUS direction:
Increase belt speed
MINUS direction:
Reduce belt speed
Anl_TC_BS_8038_SPK8.indb 15 Anl_TC_BS_8038_SPK8.indb 15 11.10.2017 11:19:44 11.10.2017 11:19:44