7.3.1 Plug-in tools
Sawing:
Sawing wood and plastic.
Notes on working practice: When sawing, watch out
for foreign bodies in the material and remove them if
necessary.
Plunge cutting is allowed only in soft materials such
as wood or plasterboard.
Sanding/grinding:
Surface sanding/grinding at
edges, in corners or hard-to-reach areas. Depending
on choice of sanding/grinding paper for the
sanding/grinding of wood, paint, lacquer, etc.
Notes on working practice:
This equipment offers particularly high performance
for the sanding/grinding of hard-to-reach corners and
edges. To sand/grind profiles and channels you can
also work with just the tip or the edge of the
sanding/grinding disk. Various sanding/grinding
papers are available, specially designed for the
different types of material you may be working on and
the amount you wish to remove from the surface. The
amount removed will depend largely on the choice of
sanding/grinding paper and pressure applied to the
sanding/grinding disk.
Scraping:
Scraping off old paint or adhesives.
Notes on working practice: Move the plug-in tool
against the area you want to remove. Begin with a flat
angle of incidence and little pressure. The surface
(e.g. wood, plaster) may be damaged if too much
pressure is used.
Diamond saw blade:
For small repairs to tiled areas
indoors and to brick walls. Notes on working practice:
Work only at high oscillating speed.
7.4 Speed control (Fig. 6)
You can select the speed by turning the speed
controller (4).
Plus direction:
Higher speed
Minus direction:
Lower speed
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the power plug before starting any
cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
We recommend that you clean the equipment
immediately after you use it.
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment.
8.2 Servicing
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts
Please provide the following information on all orders
for spare parts:
Equipment model/type
Equipment article number
Equipment ID number
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
9. Storage
Store the equipment and accessories out of children’s
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
10. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council!
16
GB
Anleitung_RT_MG_10_8_Li_SPK7:_ 27.10.2011 19:08 Uhr Seite 16
