EINHELL 42.597.79, Оригинальная инструкция по эксплуатации, Страница: 7 / 12

7
GB

Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.

CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Drill chuck
2. Drill depth stop
3. Drill/hammer drill selector switch
4. Locking
button
5. ON/OFF switch
6. Speed controller
7. Clockwise/Counter-clockwise switch
8. Additional handle
9. Speed selector switch
10. Storage compartment for drill bits
3. Proper use
The drill is designed for drilling holes into wood, iron,
non-ferrous metals and rock using the appropriate
bits.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage: 230 V ~ 50 Hz
Power input: 1050 W
Idling speed 1: 0-1,100 min -1
Idling speed 2: 0-3,000 min -1
Drilling capacity Concrete 16 mm
Steel 13 mm
Wood 40 mm
Protection class: II /
쓑
Weight: 3.3 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level 98.2 dB(A)
K
pA
uncertainty 3 dB
L
WA
sound power level 109.2 dB(A)
K
WA
uncertainty 3 dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Hammer drilling in concrete (handle)
Vibration emission value a
h
= 23.804 m/s 2
K uncertainty = 1.5 m/s 2
Hammer drilling in concrete (additional handle)
Vibration emission value a
h
= 15.382 m/s 2
K uncertainty = 1.5 m/s 2
Drilling in metal (handle)
Vibration emission value a
h
= 5.954 m/s 2
K uncertainty = 1.5 m/s 2
Drilling in metal (additional handle)
Vibration emission value a
h
= 3.590 m/s 2
K uncertainty = 1.5 m/s 2
Anleitung_RT_ID_105_SPK7:_ 21.01.2010 11:21 Uhr Seite 7