Eiki LC-X2U, Инструкция пользователя

Страница: 12 / 58

Personal computers can be connected to the HDB1 5-pin (VGA) terminal on the projector.
• Connect the computer to these terminals using the VGA cable and VGA/MAC adapter (provided).
CAUTION:
For projectors, the VGA cable provided is designed to reduce RFI (Radio Frequency Interference) emissions.
For regulatory compliance reasons, this cable must be used and must not be replaced by any other cable.
Digital output signal from the computer can be connected to the DIGITAL terminal (MDR 20-pin). When using this input,
Graphic Accelerator Board designed for this projector should be installed into your computer and set-up the computer
configuration following instruction included in the Graphic Accelerator Board package. Refer to DIGITAL INPUT
CONNECTION on page 15 and 17.
Personal computers can be connected to the computer input (Red, Green, Blue, Horiz. Sync. and Vert. Sync.) on the
projector.
• Connect the computer to these jacks using the BNC cables (not provided).
• Connect audio outputs from your computer to these jacks using the audio cable (not provided).
• When the computer is operated by projector’s remote control unit, connect three different type of cables (provided)
between projector control port and computer mouse port or serial port.
COMPUTER TYPE CABLE
IBM Compatible computer
with PS/2 mouse port. Mouse Cable for PS/2 port.
IBM Compatible computer with serial port. Mouse Cable for Serial port.
Apple Macintosh computer with ADB mouse port. Mouse Cable for ADB port.