EN-28
1. Turn off the projector and unplug the AC power
cord.
Allow the projector to cool for at least 45
minutes.
2. Place a protective sheet (cloth) beneath the
projector. Turn the projector over so you can
access the lamp cover.
3. Loosen the screws on the lamp cover and open
it.
4. Loosen the screws on the bottom of the lamp
assembly.
5. Grasp the lamp handle and pull the lamp assembly
directly out of the projector.
6. Replace with the new lamp.
7. Tighten the screws on the bottom of lamp
assembly.
8. Tighten the screws on the lamp cover.
J
Dispose of the used lamp according to local regulations.
J
Ensure that screws are tightened properly. Screws not tightened fully
may result in injury or accidents.
J
Since the lamp is made of glass, do not drop the unit and do not scratch
the glass.
J
Do not reuse the old lamp. This could cause the lamp to explode.
J
Be sure to turn off the projector and unplug the AC power cord before
replacing the lamp.
J
Do not use the projector with the lamp cover removed.
ORDER
REPLACEMENT
LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection
lamp, give the following information to the dealer.
Model No. of your projector : EIP-S200
Replacement Lamp No.
: P8384-1014
