EIJKELKAMP Scuba, Руководство пользователя

Страница: 34 / 50

34
5.8.2 Changing EBP batteries and activating logging
1 Replace all batteries at the same time and use the same brand of battery.
2 Clean all moisture, dirt, grit and any other debris off the Scuba because you are going to expose sealing surfaces as
you change the batteries.
3 Unscrew the black knob at the top of the EBP it until the battery sleeve detaches from the EBP body.
4
Remove the spent batteries and install eight C-cell batteries (or six D-cell batteries) carefully following the polarity
diagram.
5 Clean all moisture, dirt, grit and any other debris off the exposed O-ring surfaces and the inside of the battery sleeve.
Add a small amount of silicone grease to the O-rings and to the inside of the battery sleeve where the O-rings will
seat.
6 Carefully screw the battery sleeve back into place. You don’t have to tighten it closely to the EBP body; finger-tight is
fine.
7 Remember that you must first activate Scuba logging by clicking the “ Scuba Logging is OFF ” hot button so that it
changes to “ Scuba Logging is ON ” (3.3, 5.5).
Remember to look for the red LED to blink five times to confirm that logging is activated, and the green LED blink
briefly to confirm that the Scuba is receiving adequate voltage to start logging.