9
9
9
9
1
-800-497-4524 EIC SOLUTIONS, INC
.
215-443-5190
2.6 APPLY POWER
Once the air conditioner is mounted, check the serial label and confirm the voltage required and then apply
appropriate power as outlined below.
220 – 240 VAC units – this unit will not have a plug on the end. Connect the wires to an appropriate power
source using standard safe wiring methods as follows:
Wire colors are as follows:
Black or Brown – line
White or Blue – line/neutral
Green or Green/Yellow – ground
Amperage for 220 VAC unit is 8.9 amps
Upon applying power to the air conditioner the fans on the cold side (inside the enclosure) will come on. The hot
side fans (outside the enclosure) may also run depending on where the thermostat is set. The cold side fans always run
to circulate air within your enclosure thereby eliminating any “hot spots”. The hot side fans will only run when the air
conditioner is cooling – they are “pumping” the heat from the inside of your enclosure to the outside air.
