D3432
www.eibach.com
Page 2
3. Remove the reusable cotter pin and nut from both the
left and right side tie rods, then, separate the tie rods
from the spindles as shown.
(See Photos 5, 6 & 7)
4. Rotate the steering shaft so that the bolt for the steering
coupler is visible to the driver side of the vehicle, then,
with a paint pen, mark the alignment/orientation of the
steering coupler to steering rack input shaft. You can
now remove the steering coupler bolt.
Note: This is
necessary as the steering rack will need to be
removed, and must be reinstalled into the vehicle in
the exact same orientation.
(See Photos 8 & 9)
5. Disconnect the two forward electrical connections on the
steering rack.
(See Photo 10)
6. Unclip the wire harness from the top of the steering
rack.
(See Photo 11)
Photo
7
Photo
9
Photo
8
Photo
11
Photo
5
Photo
6
Paint Mark
Photo
10
