3
Introduction
Congratulations on purchasing an EiA200 Series RF RadioLINK module. This RF
module can be easily installed in the RF upgradeable EiA207 or EiA208 Series
Carbon Monoxide Alarms to provide you with an RF interconnected warning system
– when one Alarm senses carbon monoxide gas and sounds a warning, all the other
Alarms will also sound a warning. This helps to ensure the alarm sound will be heard
throughout the property.
Installation
1. The EiA200 Series Carbon Monoxide Alarm must be installed as per the
guidance in the instruction booklet ‘Battery Powered Carbon Monoxide Alarms
EiA207/EiA208 Series’.
It is advisable that all RadioLINK Carbon Monoxide Alarms should be installed
(where possible) with the antennas (see figure 1) in the same orientation (i.e.
essentially parallel). This means picking a part of the building, say the front wall
of the building and then installing all mounting plates in the same orientation with
respect to this.
2. Remove the RF module from the packaging, carefully insert into the back of the
Alarm (see figure 2). Fold over the pull tag and fit the antenna in to the slot provided
(see figure 3).
