4.
If the mains wires are recessed, bring the wires through the rear hole in the
mounting plate as shown in
Figure 4
.
If the mains wires are being brought along the surface:
(a) position the mounting plate so the cable trunking is as shown in
Figure 4
.
(b) the mounting plate has a removable section, take it out to interface directly with
25mm trunking as shown in
Figure 5
. If interfacing to 16mm trunking carefully cut
around the marked section, leaving the top intact and replace the section. (If you are
not using surface wiring, the removable section must be left in place for electrical
safety reasons).
21
REMOVEABLE
TRUNKING DOOR FOR
Figure 4
B16350-R0-Ei2100 SERIES-U&C.qxd 18/9/08 3:46 PM Page 21
