EHEIM professionel5e 450, Руководство по эксплуатации

Страница: 23 / 182

English
The factory setting for the target temperature = 24°C (75°F).
How to set the temperature:
D Press and hold the pushbutton (36) for approx 3 sec. The target temperature blinks (temperature indicator (34) and
the status indicator for the target temperature (35) blinks).
E Set the desired target temperature by pressing the pushbutton briefly. Pressing once = increase by 1°C (2°F).
When the maximum set point of 34°C (93°F) is reached, the indicator will begin again at 18°C (64°F).
F When the desired target temperature is set, wait until the indicator blinks again. Then press and hold the pushbutton
(36) for approx 3 sec. in order to store the desired target temperature. After 15 sec. without an entry, the indicator re-
turns to the display mode, and the previous setting will be maintained (child guard).
7.3 Setting mode for target temperature
7.4 System messages
Control indicator lights The target tempera-
•
The water temperature set has not yet been
up. The actual tempera- ture set is more than reached (may take up to 24 hrs).
ture and target tempera- 2°C above the water
•
The water volume is too large.
ture are displayed temperature. Raise the ambient temperature and / or
alternatively. reduce the water volume.
Control indicator is off. The target tempera-
•
Lower the temperature of the aquarium
The actual temperature ture set is more than water by colder fresh water, cold packs,
and target temperature 2°C below the water
or the like.
are displayed alter- temperature.
•
Reduce the ambient temperature.
natively. Heater cannot cool.
23
The operating panel and the software display when the filter parts need to be cleaned.
•
Implement maintenance works in case of reduced filter capacity (approx. every 3 to 6 months).
•
First, clean prefilter (8.1).
•
If prefilter cleaning insufficient: Clean all filter inserts (general cleaning 8.2).
•
If general cleaning insufficient: Clean the pump chamber. (8.3).
8
Maintenance and care
Pressing the pushbutton (36) once will display the target temperature stored. The status indicator for target tempera-
ture (35) lights up. After about 5 sec., the indicator changes back to the actual temperature.
Note: Renew the blue filter mat after the third cleaning.
8.1
Prefilter cleaning
1. Disconnect the power cable (30). 2. Disassemble the safety adapter (13) and the pump head (17) (chapter
3, step 1 - 3). 3. Remove the prefilter (3). 4. Remove the blue filter mat (1). 5. Rinse the blue filter mat (1)
under running, lukewarm water (replace if required). 6. Empty the prefilter (3) and rinse it. 7. Insert the blue
filter mat (1) into the prefilter (3). 8. Insert the prefilter (3) with the blue filter mat (1) (place onto supports
fi
arrows). 9. Check and, if required, clean the seals and treat them with EHEIM care spray (No.
4001000). 10. The prefilter flap (4) must be unobstructed. 11. Attach the pump head (17) (observe fitting
position) and close the locking clips. 12. Put the filter system into operation (chapter 5, step 17 - 23).
1. Disconnect the power cable (30). 2. Disassemble the safety adapter (13) and the pump head (17) (chapter
8.2
General cleaning