Eguana Enduro 0307, Инструкция по установке и запуску

Страница: 9 / 32

6
5 Battery Installation
Note: The battery installation and connection
instructions are applicable only if the battery is supplied
separately from the ESS. Proceed to section 6 if the
battery is pre-installed from the factory.
5.1 Mounting the battery module
1. Remove the battery module mounting brackets from
the ESS frame. (Left side shown – repeat for right
side).
2. Mount the brackets to the battery module.
Note: Clear the battery power and communication cables
away from the mounting area of the battery module.
3. Position the battery module into the base of the ESS
frame, aligning the brackets as shown right.
4. Secure the battery module using the two mounting
screws provided.
5.2 Power cable connection
CAUTION! Observe the polarity of the battery
power connections. Reverse polarity will cause
permanent damage to the system.
IMPORTANT! To prevent damage to the power
terminals, apply push in and pull out force
vertical to the connector only.
1. Plug the battery power positive and negative cables into the battery posts. Push until you feel a tactile click to
complete the connection.
5.3 Communication cable connection
1. Connect the communication cable to the
battery module port, referenced port 3 below.
Figure 8: Battery communication cable installation.
Figure 7: Battery power connections.
4 3
1
2
Figure 6: Mounting the battery.