Trimble 5600
Bluetooth Dongle
eGPS Solutions
(770) 695-3361 | www.eGPS.net
Page
3
/
3
Step
Action
Display
3
a) Power On the 5600 Robot with the
data collector connected by the cable
to the instrument and battery
b) Run through the leveling/calibration
routine
Note; The data collector instrument will need to
be set to communicate with the instrument
directly. The normal Baud rate setting will be
9600, 8, None, 1
4
a) Once the leveling routine is completed
disconnect the Data Collector and plug
in the Bluetooth Dongle (the Dongle
should be Off) to the serial port that
the collector was plugged in to. You
will need to use the Null modem
gender changer included with the
Bluetooth Dongle, once it is plugged in
turn on the Dongle.
Note; the Bluetooth Dongle used to initiate the
pairing should be at the Robot. If you do not
get communication, switch the dongles.
5
a) Connect the other Bluetooth Dongle to
the Data collector (it should be Off)
and the once it is plugged in turn on
the Dongle.
The setup is complete and you should now be
able to survey.
Whenever you move the instrument or power it
down you will need to start from step 3 again.