35
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP & LM2100
Problem
Cause
Solution
The mower does not
mulch properly
◾
◾
Wet grass clippings are sticking to the
underside of the deck.
◾
◾
The mower is set to cut too much grass
at once.
◾
◾
Wait until the grass dries before
mowing.
◾
◾
Raise the deck to a higher cutting
height setting.
There is excessive
vibration
◾
◾
The cutting blade is loose.
◾
◾
The cutting blade is unbalanced.
◾
◾
The cutting blade is bent.
◾
◾
The motor shaft is bent.
◾
◾
Tighten the blade bolt.
◾
◾
Balance the blade following the
instructions.
◾
◾
Replace the blade.
◾
◾
Contact the service center.
The handle-locking
clamps cannot be closed
in position
◾
◾
The side rails are not fully extended.
◾
◾
Fully extend the side rails, then lock
the clamps.
Mower is difficult to
pull back when the self
propel is turned off.
◾
◾
The wheels are temporarily locked.
◾
◾
Simply push ahead slightly and then
move the mower as desired.
The motor works but the
blade doesn’t cut the
grass.
◾
◾
The blade is not tightened to the required
torque.
◾
◾
Re-tighten the blade. The
recommended torque for the blade bolt
is 36-43 ft-lb (49-59Nm)
Short running time of
the mower with included
battery
◾
◾
Grass conditions and cutting height
setting will greatly affect the battery run
time. The claimed run time is based on a
light load condition.
◾
◾
Raise the blade height and slow your
pace to reduce the cutting load
