56V LITHIUM-ION CORDLESS EDGER — ED0800/ED0800-FC
22
WARNING:
Always protect
your hands by wearing heavy gloves
or wrapping the blade with rags or
other materials when performing any
maintenance on the edger blade.
To remove the blade
1. Stop the motor and remove the
battery pack.
2. Lay the edger on its back so that
the blade is facing upwards.
3. Wear protective gloves. Use a
needle nose pliers (not included)
to remove the cotter pin from the
motor shaft (Fig. 12).
4. Rotate the blade to align the slot in
the flange with the hole in the gear
case (Fig. 12).
5. Insert the hex wrench provided
into the aligned holes to act as a
stabilizer. Use the multi-function
wrench provided to loosen the nut
CLOCKWISE (Fig. 13).
6. Remove the nut, outer flange, blade,
and the inner flange from the motor
shaft (Fig. 14). Check and replace
them if they are worn.
13
Stabilizer
Multi-function
Wrench Provided
14
Slot in the Inner Flange
Outer Flange
Nut
Cotter Pin
Inner Flange
Blade
Motor Shaft
12
Aligned Shaft-locking Holes
Gear Case
Inner Flange
Cotter Pin