Ega Master 79602, Руководство по эксплуатации

Страница: 27 / 42

27
For gearless impact wrenches and small grinders, only SAE 5 W
For damp compressed air, oils are to be used that take up water (without losing the lubricating
effect) and that contain anticorrosive additives. At lower temperatures (especially for work outside) it
may be necessary to use an antifreeze lubricant (e.g., kilfrost, BP Energol AX 10, Kompranol N 74).
For saw-chain lubrication on chain saws: Machine oil with adhesive additive, viscosity c ST 49-
55’ (6.5 – 7.5E) / 50ºC
Greases (free of resins and
acids)
Multi-purpose greases for
antifriction and friction
bearings and gears
Special greases for high-speed
miter gears
Designation in accordance
with DIN 51502
KL 2 K G 00h
Consistency class (DIN 51818)
2 00
Saponification type
lithium sodium
Dripping point 185ºC 145ºC
Worked penetration
265 to 295 400 to 410
Temperature range
-25ºC to 125 ºC -25ºC to 100ºC
OILER TYPES USED ON OR WITH OUR TOOLS
Oiler to mount on the machine or connect in the hose line
Setting the oiler: The adjustment screw is visible after
removing the screw plug. The oil supply is decreased by
tightening the screw, and by loosening the screw, more
oil gets into the machine. In most cases it is sufficient to
tighten or loosen the screw by ¼ or ½ of a turn. When
plugged, clean borehole (diam. 2mm) with wire.
Correct setting: When under pressure and with the filler
screw open, the oil must bubble slightly. The filling lasts
for approx. 8 operating hours.
Line oiler
For stationary pneumatic machines and motors, the
lubrication is carried out by lined-up oilers for
horizontal or vertical installation.
Setting of oilers: Shut off air supply. Open plug. Loosen
visible lock nut with a socket wrench. Using a
screwdriver turn back the tightened screw plug by ¼ to
½ of a turn and then lock again. No oils are to get into
the borehole “a” when filling. Close plug and open the
air supply.
Correct setting: A piece of paper held for a short time in
front of the outlet must be coated with oil without drops
forming.