EG TFHA27R, Инструкция по использованию и уходу

Страница: 15 / 24

Condenser
For most efficient operation, you need to keep the
condenser clean. Remove the base grille and either
sweep away or vacuum up dust that is readily accessible.
For best results, use a brush specially designed for
this purpose. It is available at most appliance parts
stores. This easy cleaning operation should be done at
least once a year.
Drawer and Cover Removal
Drawers stop before coming
all the way out of refrigerator to
help prevent contents from spilling
onto floor. Drawers can easily be
removed by tilting up slightly and
pulling past “stop” location.
To remove drawers when the
fresh food compartment door
cannot be opened fully:
—
1. Remove food from the shelf
above the Moist ‘n Fresh drawer
and take out the shelf. Take food
off of the glass cover and out of
the drawer.
2. Remove the flexible gasket
at the rear of the Moist ‘n Fresh
drawer. Lift each end straight up
until the slots on the gasket are
free of the drawer support tabs.
3. Pull the drawer partway out,
Reach in, push the rear of the
glass up and, at the same time,
push it back until it clears the front
corner retainers.
4. Tilt and remove the cover.
5. Pull the drawer forward, lift
the front to clear stops, and remove
the drawer. If the refrigerator door
doesn’t open completely, pull the
drawer out until it hits the door.
Then lift the drawer up until it is
higher than than the drawer
supports, tilt it and take it out.
6. If tape holds Convertible Meat
Pan cover to drawer supports,
remove the tape. Pull drawer
partway out. Reach in, push the
rear of the glass up and, at the
same time, back, until it clears
front-corner retainers.
8. Tilt and remove the drawer.
After cleaning, replace in
reverse order.
9. Reinstall the gasket at the
rear of the vegetable drawer.
Fit the end of the plastic drawer
support into the slot on the gasket,
with the rubber gasket flap facing
you. Make sure the gasket snaps
into place.
(continued next page)
7. Tilt and remove the cover.
15