INSTALLATION INSTRUCTIONS
How to install the bicycle out of the box
1.
Unpack the bicycle from the box and cut all the ties that held the bicycle together during
shipping.
2.
Remove the Stem protective cover by loosening the Allen Keyed nut on stem and then Install
the handle bar by inserting the handlebar stem into the head tube.
3.
Adjust the handlebar by loosening the nut holding the handlebar and then re-tightening it with
an Allen wrench.
4.
! WARNING: Do NOT over tighten nut against the fork; for you will risk damaging your
suspension fork.
5.
The front and rear LED/reflector Lamp runs off the main battery of the bike. They can be turned
on/off by clicking the power button on the left side of the handlebar control panel
6.
Install the pedals to the bike. Each of the pedals has a letter indicating which side it needs to
be installed to. R=Right and L=Left. Install them using #15 wrench.
7.
! WARNING: Before riding the bicycle ensure the main Li-on battery is properly installed and
locked in before riding the bicycle. If the Battery is not firmly locked onto the holder. it may slide
out and cause damage to the battery.
8.
Insert the battery into the battery holder by aligning the battery to the bottom of the battery
bracket on the frame and then slowly slide the battery until both the top and bottom of the
battery aligns to the frame. When you hear a click this ensures the battery is properly locked
into the frame of your bike. Ensure that the battery is locked in by lightly tugging on the battery
outward to the left to ensure it will not slide out.
2