5
button on the Pad located to the left of the handlebar.
•
Place the PAS on any level you desire, because while the thumb throttle is engaged, the
PAS mode is not active and has no effect on the speed or power of the electric motor.
•
Depress the thumb throttle in any increments of power you desire to power the motor of
the bicycle and it will take off as demanded.
•
This mode can be used in conjunction with any of the above modes as the amount of
motor power supplied while twisting the thumb throttle overrides all PAS modes the
system is set to.
•
You can engage this mode whenever you want as long as the system is turned “ON”.
•
While peddling will lighten the motor load and assist lower the demand on the electric
motor, you do not need to pedal in this mode of operation.
•
! CAUTION: This mode is designed to achieve a speed of 20 MPH. User discretion is
advised
•
The motor will NOT stop when you stop peddling while the thumb throttle is engaged.
•
The motor will stop if the brake lever is depressed even if the thumb throttle is engaged.
•
! CAUTION: Remember to let go of the thumb throttle when getting on or off the bike
weather or not the brake levers are engaged.
•
In this mode, the electric bike will use the most amount of battery power it will use the
most amount of battery power compared to any PAS modes on this bike.
•
This mode will give you the least “miles per charge” compared to any of the above modes
of operation
•
To assist the motor from a dead stop in this mode, it is suggested to gear down to lower
gears before stopping your bike.
About the Brake Safety Feature on all EG Electric Bikes
•
ALL our electric bikes make use of a wired brake lever kill switch for safety purposes.
When the brake lever is engaged, it sends a kill signal to the controller to disable the
motor under all circumstances and condition. This will ensure the motor does not
continue to spin when you need the bicycle to stop.
How to Operate the Display Unit
•
Pressing “Power” button turns ON the electrical system to your bike.
•
Pressing and releasing (clicking) “Power” button once the system is ON toggle between
Odo = Odometer, Trip = Tripmeter, Max = Max speed, AVG = Average Speed and Time =
Total time
•
Pressing and holding “Power” button for 3 seconds will turn OFF the system
•
Pressing “+” or “-” adjusts the PAS mode to the desired levels as indicated to the right of
the display.
•
Pressing and holding “+” button for 3 seconds Turns the LED Lamp On/Off
•
Pressing and holding “-” button will engage the walk assist. The motor will keep turning
as long as the button is held down.
•
Depressing the brake levers on your bike will engage brake lights. This bike features a
dual stage rear LED lamp that allows the brake light to come on brighter when the LED
lamps are turned on as you engage the Brake levers.
•
To reset the Trip meter, Max & Average Speed, Press and hold “+” and “-“ simultaneously
