EFI Splash RPX-i, Руководство по устранению неисправностей, Страница: 13 / 20

T
ROUBLESHOOTING
13
4 Press System Settings > System Settings > Network Controller Settings > Network Settings on
the control panel.
5 Select “2 TCP/IP - Get IP Address,” and then press Change Settings.
6 Select Manual, and then press Save.
7 Select “3 TCP/IP - IP Address,” and then press Change Settings.
8 Type “192.168.000.002” on the keypad and press Save.
N
OTE
:
If the IP address is correct, no update occurs. In this case, reboot the Fiery manually.
For more information, see “To restart the Fiery manually” .
9 Select “4 TCP/IP - Subnet Mask” and press Change Settings.
10 Type “255.255.255.000” on the keypad and press Save.
11 Press Close > Close > Close > Close, and then press Exit.
Restarting the Fiery
After you set the IP address, the Fiery should automatically reboot and print a Start Page. You
can then check that the IP address on the Fiery Start Page is correct. If it is not, you must go
back to the copier and reset the IP address.
T
O RESTART THE
F
IERY MANUALLY
1 Turn off the copier.
2 Wait one minute, and then turn on the copier.
It takes a few minutes for the Fiery to restart and print the Start Page.
You may have to wait a few minutes for the Fiery to restart and print the Start Page and for
the Splash RPX-i to detect the Fiery. The Splash RPX-i will not complete a connection until
the Fiery Start Page prints.
Once the connection is successful, a Splash Startup Page prints.