EFI Fiery Central Solo, Руководство по обслуживанию

Страница: 36 / 72

36 Service Guide: Fiery Central Solo for KM
Service Procedures
DIMM
A DIMM (dual in-line memory module) is held in place by levers at the end of the DIMM socket.
The standard memory configuration is 4GB of memory.
To remove or replace a DIMM
1 Shut down and open the FC Solo (see page 22 ).
To remove a DIMM, you must remove the side panel.
2 To release a DIMM, push outward on the levers on each side of the DIMM.
Figure 16: Removing or replacing a DIMM
3 Lift the DIMM straight out of the socket.
4 To replace a DIMM, position the DIMM in the socket and press the DIMM straight down into the socket so the
levers lock the DIMM into place.
Note: DIMM fits in the socket only one way. The notch on the bottom of each DIMM should line up with the notch
in the socket.
Make sure that the levers close securely around the ends of the DIMM and the DIMM is fully seated in its socket.
5 Reassemble the FC Solo and verify functionality (see page 50 ).
6 If you installed a new DIMM, make sure to reset the system date and time (see page 30 ).
1 Lever
2 Socket notch
3 DIMM
1
2
3
1