22
Service Guide: Fiery Central Solo for KM
Service Procedures
Shutting down the system
If the FC Solo is powered on, you must shut down the system and remove the power cable from the connector panel
before removing or connecting interface cables or accessing the internal components.
If you are cycling power, wait at least 10 seconds before powering back on.
If you are unable to shut down the FC Solo from the monitor, power off by holding down the power button on the front
of the FC Solo for up to eight seconds.
Using the reset button may cause the system to operate unpredictably; therefore, use the reset button on the front of
the FC Solo only if the system is frozen and unresponsive to keyboard or mouse actions.
To shut down the FC Solo
Always verify that the FC Solo is not in use before you begin the following procedure.
1
Ensure that the FC Solo is not receiving, processing, or printing any files.
If the system has just finished processing, wait at least 10 seconds after the system reaches Idle before beginning
the shutdown procedure.
Note:
Notify the network administrator before you remove the FC Solo from the network.
2
On the monitor, click the Windows Start button and then click Shut down.
Before accessing internal components, make sure that all cables are disconnected from the back of the FC Solo.
Opening the FC Solo
To service internal components, you must open the FC Solo when you need to repair or replace any components.
To open the FC Solo
1
2
Remove all external cables from the FC Solo.
3
Remove all panels necessary to access the component that you want to service.
For guidelines on which panels to remove, see the service procedure for the component that you want to service.
Note:
When removing multiple panels from the FC Solo, use the following order:
•
Side panel (see
•
Top panel (see
•
Note:
When replacing panels, reverse the order.
WARNING
Always obtain permission from the network administrator before you take the FC Solo off the network.