EFI Fiery Central Solo, Руководство по обслуживанию, Страница: 31 / 72

31 Service Guide: Fiery Central Solo for KM
Service Procedures
Motherboard jumpers
Jumper configuration should not be changed.
Table 1: Jumper pins on the motherboard
Power and reset buttons
Align the triangle on each cable connector with the correct pin as shown in Figure 13 .
•
Power button: J15, pins 6 (red cable) and 8 (white cable)
•
Reset button: J15, pins 5 (green cable) and 7 (white cable)
Figure 13: Cable connections for power button
CAUTION
The following table describes the jumper pin locations on the motherboard. Do not move or change
any of the default jumper configurations.
Jumper Description
J4 (default) J4 is the Clear CMOS and Password jumper. Default configuration: jumper cap installed
on pins 2 and 3.
Note:
Because the jumper cap is very small, it is not necessary—and could
introduce an error—to remove the jumper cap in order to clear the CMOS
settings.
Pin 1
10 9
PWR
1 2
RST