EFI EB-34, Инструкция по установке и обслуживанию, Страница: 72 / 117

72 Installation and Service Guide: Printer Controller EB-34
Replacing Parts
2 Place the bracket inside the chassis and secure it using the three screws that you removed earlier.
3 Attach the power and data combination cable to the back of the DVD drive (see Figure 9 on page 37 and Figure 10
on page 38).
4 Reassemble the EB-34 and verify functionality (see page 72 ).
5 If you installed a new DVD drive, make sure to reset the system date and time. For more information, see “To
configure the system date and time” on page 48.
Restoring and verifying functionality after service
Before you leave the customer site, make sure that you complete the following steps. If you cannot complete a step,
determine the reason and correct the problem before continuing. For more information, see “Troubleshooting” on
page 93.
To reassemble the EB-34 and verify functionality
1 Reseat all boards, cables, connectors, and other parts loosened or removed during service.
When routing cables inside the EB-34, make sure that:
•
Cables are securely installed after routing cables
•
Cable routing does not interfere with the operation of internal components nor interfere with removing or
replacing components
•
Cables are not tangled nor looped around internal circuit boards, or components (such as capacitors and
resistors)
•
Cables do not lie on or against any internal heating element
•
Cables do not interfere with opening or closing EB-34 panels
•
Cable slack is secured with a tie-wrap
2 Restore the EB-34 to the upright position.
3 Replace any panels that you removed earlier, as described on page 39 .
4 If you replaced the motherboard, make sure that the new motherboard solves the problem that you are
troubleshooting, and then transfer options to the new motherboard (see page 56 ).
5 Connect the power cable to the EB-34 (see page 17 ).
6 Connect the EB-34 to the copier (see page 17 ).