EFI E-45, Инструкция по установке и обслуживанию, Страница: 78 / 126

78 Installation and Service Guide: Color Controller E-45
Replacing parts
12
Slide the power supply toward the front panel and take the power supply off from under the chassis bar.
Figure 33:
Removing/replacing the power supply
To replace the power supply
1
Make sure that the E-45 is in upright position.
2
Position the power supply inside the chassis (see Figure 33 on page 78).
Insert the power supply unit under the chassis bar, and place the power supply on top of the left and right chassis bars.
Position the power supply so that it is flush against the connector panel.
3
Install the inside screw with washer to secure the power supply unit to the chassis top.
1 Power supply unit
2 Chassis bar
3 Screw (1 of 4)
4 Inside screw
Note:
To service the power supply, place the E-45 in an upright position.
1
3
2
4