62
Installation and Service Guide: Color Controller E-45
Replacing parts
2
Remove the 10-pin power button cable that connects the printer interface board and the motherboard.
3
Remove all boards installed in slots on the motherboard.
Note the location of the slot where each board resides so that you can reinstall the board in the same slot later.
4
Remove the following cables from the old motherboard:
Note:
First remove any plastic cable clamp(s) securing internal cables and tie-wraps.
•
Rear fan cable
•
Fiery QuickTouch power/LED cable
•
Fiery QuickTouch USB port cable
•
DVD drive cables:
•
SATA data cable
•
Power and data combination cable
•
Hard disk drive cables:
•
SATA data cable
•
Power supply cable
•
24-pin motherboard power cable
•
8-pin motherboard power cable
•
CPU fan cable
•
In-line spectrophotometer cable
For motherboard connector locations, see
To remove the motherboard
Note:
This procedure assumes that you have already performed the procedure
“To remove boards and cables from the
1
Remove all the mounting screws securing the motherboard to the chassis (for screw locations, see
).
2
Remove the motherboard from the chassis.
Lift the edge of the motherboard. Make sure that the motherboard connectors clear the chassis while you lift it out of
the chassis. Do not touch the contacts and avoid using excessive force.
Important:
During service, avoid using excessive force and always place the motherboard on a grounded,
non-metallic, static-free surface. Never allow any metal to touch the solder contacts on the underside of the
motherboard, especially beneath the battery socket. Improper handling can short-circuit and permanently damage the
motherboard.