EFI E-45, Инструкция по установке и обслуживанию, Страница: 50 / 126

50 Installation and Service Guide: Color Controller E-45
Replacing parts
Accessing internal components
Shut down and open the E-45 when you need to inspect or service internal components.
Shutting down the system
You can shut down the E-45 from the E-45 Fiery QuickTouch. When shutting down the E-45, do the following:
You can shut down the E-45 from the Fiery QuickTouch or the printer touch panel.
Note:
If the power synchronization is set to ON, you can shut down the E-45 by turning off the printer using the main
power switch.
When shutting down the E-45, do the following:
• Remove the power cable from the connector panel before removing or connecting interface cables or accessing the
internal components.
• If you are cycling power, wait at least 10 seconds before powering back on.
• If you are unable to shut down the E-45 through the Fiery QuickTouch, power off by holding down the power button on
the side of the E-45 for up to eight seconds.
For more information on how to shut down the E-45, see page 41 .
Opening the E-45
To service internal components, open the E-45 as described in the following procedure.
To open the E-45
1
Shut down the E-45 (see page 50 ).
2
Remove all cables from the back of the E-45.
3
Remove the E-45 from the furniture.
7 Power switch cables Fiery QuickTouch J352connector (pin 5, 6) on the printer interface
board Align triangle on
cable connector as
shown.
8 LED cable Fiery QuickTouch J352connector (pin 7, 8) on the printer interface
board
9 10-pin power button cable J351connector on the
printer interface
board Motherboard FP Header connector (J15)
Note:
See the connection label attached inside the chassis.
Important:
Remember that when the E-45 is powered off, network access to the printer is interrupted. Always obtain
permission from the network administrator before you take the E-45 off the network.
LED + LED -
SW
（ Red/W