EFI E-45, Инструкция по установке и обслуживанию, Страница: 14 / 126

14 Installation and Service Guide: Color Controller E-45
Installing Hardware
Installing Hardware
About the installation process
It is strongly recommended that you review this chapter before you install the E-45. Also keep in mind that installation
problems are easier to avoid and diagnose if you proceed from the component level to the system level, verifying
functionality at each step.
Since the E-45 is connected to the customer’s network, be sure to coordinate your installation schedule with the
administrator at the customer site. For information about network setup, refer the site administrator to
Configuration Guide , which is part of the user documentation set.
If necessary, you can change the default language of the E-45 set at the factory (see “To change the E-45 language” on
page 15).
Note:
You can change the default language that is preinstalled at the factory using the Configure tool available through
Command WorkStation and WebTools. Start Configure, choose Fiery Server > Regional Settings. From the Server
Language list, select your language and then click Save. When an Alert dialog box appears, click Continue. It takes up to
15 minutes to change languages.
You can also change the default language using the Fiery Quick Touch menu. Select Quick Launch > Settings, and log in to
the server as admin. From the language drop-down list, select the your language, save the changes, and then reboot the
server. It takes up to 15 minutes to complete the language changes.
To install the E-45
1
Check installation requirements and verify site conditions.
If possible, obtain verification that the network is operational (see page 15 ).
2
Unpack the E-45 (see page 17 ).
3
If applicable, connect the monitor, keyboard, mouse, and furniture to the E-45.
For more information on setting up the furniture, see the documentation that comes with the furniture kit.
4
Connect the following cables (see page 18 ).
• Printer interface (Data Transfer Unit) cables
•
Network cable (upper RJ-45)
• Crossover Ethernet cable (lower RJ-45)
5
(Optional) If the E-45 requires a static IP address (for example, in a non-DHCP network environment), work with the
site administrator to configure a static IP address.
6
Complete the installation (see page 27 ).
Remind site administrator to install current user software on client computers that print to the E-45 (see Printing and
Utilities , which are part of the user documentation set).