EFI E-45, Инструкция по установке и обслуживанию, Страница: 27 / 126

27 Installation and Service Guide: Color Controller E-45
Installing Hardware
2
Set the switch on the printer interface board to the ON position.
Figure 9:
Power Synchronization switch
3
Power on the printer.
The E-45 automatically starts up.
To disable the power synchronization
1
Turn off the printer using the main power switch.
Wait until the E-45 shuts down.
2
Make sure that the power switch on the connector panel of the E-45 is OFF position (|).
3
Set the switch on the printer interface board to the OFF position.
4
Start the E-45 (see page 41 ).
Completing the installation
To complete the installation of the E-45 at the customer site, do the following:
1
Print the Test Page and Server Configuration page (see “Printing E-45 pages from the monitor, keyboard, and mouse”
on page 29).
Important:
Do not change the switch position when the E-45 is powered on.
1 Set the switch to the ON position
Important:
Do not change the switch position when the E-45 is powered on.
1