
H = Placing the base inside the pod
Note:
Use the handle holes for easier lifting. While lifting aim the smaller
slots at the back of the base towards the brackets on the screens.
Bracket
Bracket
Step 2:
Place the base upside down and insert the table top inside
the cut-out with cord outlet upwards, towards base bottom
edge.
Step 3:
Mount M6-screws and screw heads as illustrated to the
brackets. Fixate the table top and make sure it´s in level
with the base.
Cord outlet
Step 4:
Plug in the power cord and lift in the base according to illustration
H
.
Note:
For easier access to place the cord in the track: perform illustration
F
before these steps.
I = Assemble the Table Top-electronics mounting kit (ex: A50B34)
Step 1:
Mount the two brackets according to illustration with the
flange pointed towards the bottom. Replace screws with the
new, longer ones.
Bracket
New screws
Bracket
Bracket
Screens
Beam
Base
Box
Table top
Bracket
Power cord
Screw head
Screw
Slot
Handle holes